低压控制器Controller

  • 产品详情
  • 产品参数


产品概述 Product description

PSTNc型无功功率自动补偿控制器,适用于低压配电系统电容补偿装置的自动调节,使功率因数达到用户预定状态,提高电力变压器的利用效率,减少线损,改善供电的电力质量。


PSTNc   reactive   power   automatic   compensating   controller   applies   to automatic   adjustment for capacitor compensator of low-voltage   power distribution system to   make   power factor reach status   preset   by   user, improve utilization rate of transformer,reduce line loss and improve electric quality of power supply.


功能特点 Function features

● 控制器在高速采样计量基础上,应用我公司第三代电容器投切算法理论,投切电容更为合理,补偿更为精确,并且高度监控电容动作频率、时间,使之均衡投切,有效的延长机械产品使用寿命 ;

● 全中文显示界面,大屏幕液晶;

● 快速瞬变(脉冲群)干扰试验、振动试验、跌落试验、高低温老化试验满足相关国家标准。EMC电磁兼容性试验、环境试验满足相关IEC标准;

● 三相电压、电流、有功功率、无功功率、功率因数实时检测显示;

● 测量三相电压、电流2-15奇偶次谐波含有率及谐波总畸变率;

● 过压、欠压、过谐等各种报警功能;

●12/24路输出控制。共、分路数可任意设置组合成共补、分补及共分混合补偿方式(24路为增强型 PSTNc900i系列);

● 动静态可在一机实现两种控制模式;

● 可实现动静态双模一体;

● 具有RS485端口、采用通用MODBUS协议与后台通讯;

● 采用先进的电容投切控制理论配套后台监控软件。可实现后台监控;

● 手动调试。


Controller shall apply for G3 capacitor switching algorithm theory based upon hi-rate sampling measurement,switching capacitor becomes more reasonable,compensation more precise,and intensive control of capacitor   activation frequency and time for balanced switching and efficient extension for life of use (for mechanical products);

Full Chinese display interface,Larger LCD;

Fast   instantaneous(pulse   grouping)interruption   test,vibration   test,falling test,hi-/low-temperature   anti-age   test   should   be   subjected   to   relative national standards.EMC test,environmental test should be subjected to relative IEC standards;

Real-time inspection and display for 3-phase voltage,current,active power, reactive power and power factor;

Measurement of odd-times harmonic content rate of 3-phase voltage and current and its total distortion rate;

Functions for over-voltage,under-voltage and excessive harmonic wave etc;     12/24-route   input   control.Mutual-compensation   or   slave-compensation route   shall   be   set   and   combined   into   mutual-compensation   or   slave- compensation and mutual parate mixing compensation modes.(24-route is enhanced PSTNc900i series);

Dynamic/static status may enter into two control modes in one computer;

Dynamic and static dual mode;

It still has RS485 port that communicates with background through general MODBUS protocol;

It applies to advanced capacitor switching control theory and match with background control software for further background control;

Manual commissioning.


详细参数 Teachnical data

● 额定电压:AC220V

● 允许偏差:±20%

● 电压波形:正弦波,总畸变率不大于 5%

● 频率:50Hz,允许偏差 ±1.5Hz

● 海拔高度:79.5kPa~106kPa(2500 米 )

● 环境温度:-15℃~+60℃

● 相对湿度:空气湿度在20℃时90%,在温度较低时,允许有较高的相对湿度

● 环境条件:周围介质无爆炸危险、无足以损坏绝缘及腐蚀金属的气体,无导电尘埃

●   额定值 Un:220V

●   测量范围:0-1.6Un

●   测量误差:≤0.5%

●   过载能力:1.8Un可连续工作

●   功耗:≤10W


●   Rated voltage:AC220V

●   Allowable tolerance:±20%

●   Voltage wave form:sine wave,total distortion rate of less than 5%

●   Frequency:50Hz,allowable   tolerance:±1.5Hz

●   Altitude:79.5kPa~106kPa (2500m)

●   Ambient temperature:-15℃~+60℃

●   Relative humidity:allowable higher relative humidity at 20℃ temperature is 90%(relative lower temperature)

●   Ambient conditions:free explosion risk around it,free gas corrosive with insulator or metal,free from conductive dust

●   Rated value (Un):220V

●   Measure range:0-1.6Un     C.Measure tolerance:≤0.5%

●   Overload capacity:continuously run at 1.8Un

●   Power consumption:≤10W


型号
PSTNc900I
概述
PSTNc900I型无功功率自动补偿控制器,适用于低压配电系统电容补偿装置的自动调节,使功率因数达到用户预定状态,提高电力变压器的利用效率,减少线损,改善供电的电力质量。